Advantech UTC-520 Manuel d'utilisateur télécharger pdf (Page 27)

19 UTC-515/520/532 User Manual

Chapter 2 System Setup

2.2.3 UTC-532

A. Power Switch F. Antenna Port

B. USB 2.0 x 4 G. Line-out

(USB 3.0 x 1 for UTC-532D; H. Mic-in

USB 3.0 x 2 for UTC-532C/E) I. COM3 (UTC-532A only)

C. HDMI Port J. COM2

D. VGA Port K.COM1

E. LAN Ports x 2 L. AC input

2.3 Setup Procedures

2.3.1 Power on UTC

1. Connect an adaptor with input voltage rated 12V/5A for all UTC-515 and UTC-

520A/B/D SKUs.

2. Connect an adaptor with Input voltage rated 12V/7A for UTC-520C/E SKUs.

3. Connect an AC power cable for all UTC-532 SKUs.

4. Be sure always handle the power cords by holding the plugs ends only. Please

refer to I/O Ports section above to find the DC or AC inlet and power switch.

5. Press Power On/Off. The PWR LED will turn green.

2.3.2 BIOS setup on UTC

In most cases, the UTC has been properly set up and configured by the dealer or SI

prior to delivery. However, it may still be necessary to use the BIOS (Basic Input-Out-

put System) setup program to change system configuration information, such as the

current date and time or your type of hard drive currently installed. The setup pro-

gram is stored in read-only memory (ROM). It can be accessed either when you turn

on or reset the UTC, by pressing the “Del” key on your keyboard immediately after

powering on the computer. The settings you specify with the setup program are

recorded in a special area of memory called CMOS RAM. This memory is backed up

by a battery so that it will not be erased when you turn off or reset the system. When-

ever you turn on the power, the system reads the settings stored in CMOS RAM and

compares them to the equipment check conducted during the power on self-test

(POST). If an error occurs, an error message will be displayed on screen, and you

will be prompted to run the setup program.

AB E FGHI J K LCD

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 50 51

Pas de commentaire

Advantech UTC-520 Manuel d'utilisateur Page 27