Advantech ADAM-4572 Manuel d'utilisateur télécharger pdf (Page 26)

Chapter 2 Getting Started 17

2.2.3 Power Connection

You should take the following steps to connect ADAM-4579 power.

1. Connect the power cable to 2-pin connector

2. Connect power cable to power adapter

If the ADAM-4579 is working properly, the green power LED will light

2.2.2 Network Connection

There are two ways to use the 10/100Base-T Ethernet connector

located on the ADAM-4579 :

1. For Local Area Network (LAN) applications using the

ADAM-4579, you will simply plug one end of your Ethernetcable into

the 10/100Base-T connector, and the other end into the hub connected

to your network.

2. When installing and configuring, you will find it convenient to hook

the ADAM-4579 directly to your computer’s Ethernet card. To do this

you will need to use a “crossed-cable”, such as the one supplied with

your server.

Cabling requirements for the Ethernet side

Use an RJ-45 connector to connect the Ethernet port of the ADAM-

4579 to the network hub. The cable for connection should be Category

3 (for 10Mbps data rate) or Category 5 (for 100 Mbps data rate) UTP/

STP cable, which is compliant with EIA/TIA 586 specifications.

Maximum length between the hub and any ADAM-4579 is up to 100

meters (ca. 300 ft).

S-232/ 4

22/48

ort2

ort1

Dual Speed Hub

Category 5

EIA/TIA 568

UTP Cable

100m

ADAM-4579

ADAM-5510

Figure 2-11 Connecting ADAM-4579 series to the hub

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 66 67

Pas de commentaire

Advantech ADAM-4572 Manuel d'utilisateur Page 26