Advantech EKI-7659CPI Manuel d'utilisateur télécharger pdf (Page 51)

41 Chapter3

Figure 3.8: System Information

IP Configuration

User can configure the IP Settings and DHCP client function here.

• DHCP Client: To enable or disable the DHCP client function. When DHCP client function is enabled,

the industrial switch will be assigned the IP address from the network DHCP server. The default IP

address will be replaced by the DHCP server assigned IP address. After user click “Apply” button, a

popup dialog show up. It is to inform the user that when the DHCP client is enabling, the current IP will

lose and user should find the new IP on the DHCP server.

• IP Address: Assign the IP address that the network is using. If DHCP client function is enabling, and

then user doesn’t need to assign the IP address. And, the network DHCP server will assign the IP

address for the industrial switch and displays in this column. The default IP is 192.168.1.1.

• Subnet Mask: Assign the subnet mask of the IP address. If DHCP client function is enabling, and then

user does not need to assign the subnet mask.

• Gateway: Assign the network gateway for the industrial switch. The default gateway is 192.168.1.254.

• DNS1: The abbreviation of Domain Name Server—an Internet service that translate domain name into

IP addresses. Domain name are alphabetic which are easy to be remembered. Because the Internet is

based on IP address; every time you use a domain name, therefore, a DNS service must translate the

name into the corresponding IP address. For example, the domain name www.net.com might

translate to 192.168.1.1

• DNS2: The backup for DNS1. When DNS1 cannot function, DNS2 will then replace DNS1 immediately.

•

And then, click

Apply

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 100 101

Pas de commentaire

Advantech EKI-7659CPI Manuel d'utilisateur Page 51