Advantech MIC-5332 Manuel d'utilisateur télécharger pdf (Page 47)

Note:

The IPMC firmware provides an OEM IPMI command to allow users to switch the

IMPC/FPGA connected NC-SI interface between the front panel LAN IO and the Base

interface LAN controllers and also to select between the 2 IO and BI connections. See

below the description of the corresponding OEM commands:

LAN controller interface selection

The BMC firmware provides an OEM IPMI command to allow users to switch the BMC

connected NC-SI interface between two front panel LAN IO RJ-45 connector and the

Base interface (0/1). These commands can be used to read out the actual selected

IPMI-over-LAN / Serial-over-LAN interface and to change the selection.

LAN controller interface selection settings:

00h: Front panel LAN IO

01h: LAN BI (default)

Read LAN Interface selection:

Response:

Change LAN Interface selection:

Response:

LAN controller channel selection and priority

In addition to the selected LAN controller interface, users may need to configure each

single LAN controller channel (port) as dedicated NC-SI interface to the BMC.

Additional OEM commands for the configuration of the NC-SI LAN controller channel

selection and priority are provided to allow a flexible configuration.

39 28 00

ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x00 <setting>

39 28 00

setting

ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x04 0x00

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 128 129

Pas de commentaire

Advantech MIC-5332 Manuel d'utilisateur Page 47