Advantech PPC-L126 Manuel d'utilisateur Page 1

Panel PC user’s Manual ed1 PPC-L60T VIA Eden Processor-based Fanless Panel PC with 6.4 TFT LCD. Contents Chapter 1 General information Chapter 2 Sys

Chapter 3 Jumper Setting and Connectors. 3.1 Jumpers The motherboard of the PPC-L60T has a number of jumpers that allow you to configure your system

Table 3.2: Connectors CN10 PC/104 expansion CN11 IDE hard drive connector CN12 COM2 port connector CN13 IR connector CN14 Audio connector CN15 P

3.3 Locating jumpers Figure 3.1: Jumper locations

3.4 Locating Connectors Figure 3.2: Connectors (component side) 11 Chapter 2

Figure 3.3: Connectors (solder side)

3.5 Setting Jumpers You may configure your panel PC to match the needs of your application by setting jumpers. A jumper is a metal bridge used to cl

3.6 Clear CMOS (S2) Warning! To avoid damaging the computer, always turn off the power supply before setting “Clear CMOS.” Before turning on the

3.7 COM port connector (CN20,CN12) The motherboard of PPC-L60T provides two serial ports (COM1: RS-232; COM2: RS- 232/422/485) in one DB-9 connector

3.9 Watchdog timer configuration An on-board watchdog timer reduces the chance of disruptions which EMP (electro-magnetic pulse) interference

Chapter 4 Hardware Installation and Upgrading 4.1 Introduction The panel PC consists a PC-based computer that is housed in a metal rear cover and. You

Chapter 1 General information 1.1 Introduction The PPC-L60T panel PC is a VIA low-power Eden processor computer that is designed to serve as a hum

Fig 4-1 Fig 4-2

Fig 4-3 Fig 4-4

Chapter 5 Mounting Instructions 5.1 Panel Mounting The PPC-L60T can be mounted into a panel. Panel Mounting can help system integrators conveniently i

5.1.2 Installation procedure To mount the PPC-L60T into the Panel: ¾ Panel Mount (1) Panel Mount 1. There are seven holes located along the four

Figure 5.2 Panel Mounting

Figure 5.3 Panel Mounting 5.1.3 Cut-out area Refer to Figure 5-3 below for the locations and dimensions for the cut out area and mounting holes.

Figure 5.3: Dimension of Panel mounting holes.

1.2General Specifications General z Dimensions(WxHxD): 218x151x74.2 mm (8.58"X5.94"X2.92 ") z Weight:1.8 kg (6.6 Ibs) z Power supp

selection and software enabled/disabled. Battery: 3.0V @ 195 Ma lithium battery Audio function Chipset: VIA82C686 South Bridge. Audio c

1.3 LCD specifications z Display Type 6.4” TFT LCD z Max. Resolution 600 X480 z Colors 262K z Dot Size(mm) 0.203 x 0.2

Chapter 2 System Setup 2.1 A Quick Tour of the Panel PC Before you start to set up the Panel PC, take a moment to become familiar with location and p

2.2 Installation Procedures 2.2.1 Connecting the power Cord The Panel PC can only be powered by a DC electrical outlet 12~24 voltage, Max 3.5A). Be

The settings you specify with the setup program are recorded in s special area of memory called CMOS RAM. This memory is backed up by a battery so tha

2.5 Installing the Drivers After installing your system software, you will be able to set up the Ethernet, VGA, audio, and touch screen functions. All