Advantech MMP3-21 Manuel d'utilisateur Page 41
- Page / 112
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Advantech SOM-Express Design Guide
Chapter 5 Carrier Board Design Guidelines 41
5.1.2 Design Guidelines
5.1.2.1 Differences among PCI Slots
Most PCI signals are connected in parallel to all the slots (or devices). The
exceptions are the following pins from each slot or device:
Table 5.2 Carrier PCI Slots
IDSEL : Connected (through resistor) to a different AD line for each slot.
CLK : Connected to a different SOM-Express PCI clock signal for each slot.
INTA# ~ INTD# : Connected to a different SOM-Express interrupt signal for each slot.
REQ# : Connected to a different SOM-Express request signal for each slot, if used.
GNT# : Connected to a different SOM-Express grant signal for each slot, if used.
Each signal connects differently for each of the four possible slots or devices as
summarized in the following PCI Slots/Devices Table 5.3
Table 5.3 Carrier PCI Slots/Devices Interrupt Routing Table
SOM-EXPRESS PCI Slot 0 PCI Slot 1 PCI Slot 2 PCI Slot 3
AD20
( Pin D39)
IDSEL - - -
AD21
( Pin C42)
- IDSEL - -
AD22
( Pin D40)
- - IDSEL -
AD23
( Pin C43)
- - - IDSEL
INTA#
( Pin C49)
INTA# INTB# INTC# INTD#
INTB#
( Pin C50)
INTB# INTC# INTD# INTA#
INTC#
( Pin D46)
INTC# INTD# INTA# INTB#
INTD#
( Pin D47)
INTD# INTA# INTB# INTC#
- Advantech 1
- Notices 2
- Revision History 2
- Table of Contents 3
- 4 Table of Contents 4
- Table of Contents 5 5
- 6 Table of Contents 6
- Table of Contents 7 7
- 8 Table of Contents 8
- Chapter 1 Introduction 9
- 1.2 Referenced Documents 10
- 2.1 Overview 11
- 2.2 Specifications 13
- 2.2.1 SOM-5780 14
- 2.2.2 SOM-5782 16
- 2.2.3 SOM-DB5700 18
- 2.3 System Resources 19
- 2.3.1 SOM-5780 Resources 19
- 2.3.2 SOM-5782 Resources 22
- 2.4 PCI Routing 25
- 2.5 DC Specifications 25
- 2.5.1 Interface I/O Voltage 25
- 2.5.1.3 Audio 27
- 2.5.1.4 VGA 27
- 2.5.1.5 LCD 28
- 2.5.1.6 IDE 28
- 2.5.1.7 Ethernet 28
- 2.5.1.8 TV-Out Bus 28
- 2.5.1.9 IrDA 28
- 2.6 AC Specification 29
- 2.6.1 PCI-Bus AC Spec 29
- 2.6.3 Audio AC Spec 29
- 2.6.4 VGA AC Spec 29
- 2.6.5 IDE AC Spec 30
- 2.6.6 I2C AC Spec 30
- 2.6.7 SMBus AC Spec 30
- Chapter 3 Pin Assignments 31
- 3.1 Row A 32
- 3.2 Row B 33
- 3.3 Row C 34
- 3.4 Row D 35
- 4.1 Nominal Board Stack-Up 36
- Thickness 37
- 4.3 Alternate Stack Ups 39
- 5.1 PCI-Bus 40
- 5.1.1 Signal Description 40
- 5.1.2 Design Guidelines 41
- Vtest 0.4 Vcc 1.5 V 42
- Tskew 2 (max) 2 (max) ns 42
- 5.1.3 Layout Guidelines 44
- Carrier 45
- 5.1.4 Application Notes 46
- 5.2.1 Signal Description 47
- 5.2.2 Design Guidelines 47
- 5.2.3 Layout Guideline 48
- SOM-Express 49
- USB Connector 49
- 5.2.3.4 Stubs 50
- 5.3.1 Signal Description 51
- 5.3.2 Design Guidelines 51
- 5.3.2.3 Azalia: 52
- Analog Ground 53
- 5.3.3 Layout Guidelines 54
- ± 15% 54
- 5.4 VGA 56
- 5.4.1 Signal Description 56
- 5.4.2 Design Guidelines 57
- 5.4.3 Layout Guideline 57
- VGA Connector 58
- 5.5 LVDS 59
- 5.5.1 Signal Description 59
- 5.5.2 Design Guideline 59
- 5.5.3 Layout Requirements 60
- 5.6 Primary IDE0 61
- 5.6.1 Signal Description 61
- 5.6.2 Design Guidelines 61
- IDE bus IDE cable 62
- Total Max 62
- Length 13 inches 62
- Carrier Board 62
- 5.6.3 Layout Guidelines 63
- 5.7 Ethernet 64
- 5.7.1 Signal Descriptions 64
- 5.7.2 Design Guidelines 64
- LAN Connector 65
- 5.7.3 Layout Guidelines 66
- 5.7.3.2 Transformer 67
- 5.7.3.3 Critical Dimensions 68
- 5.8 TV-Out 70
- 5.8.1 Signal Descriptions 70
- 5.8.2 Design Guidelines 70
- TV DAC Filter 71
- 5.9 Miscellaneous 72
- Carrier board 74
- 5.10 PCI Express Bus 77
- 5.10.1 Signal Description 77
- Pin Signal I/O Description 77
- 5.10.3.1 Differential pairs 81
- Guidelines 82
- L1 L2 L3 Capacitor Value 83
- L1 L2 Capacitor Value 83
- 5.11 Serial ATA 84
- 5.11.1 Signal Description 84
- 5.11.2 Design Guidelines 84
- 5.11.3 Layout Guidelines 85
- 5.12 LPC 87
- 5.12.1 Signal Description 87
- 5.12.2 Design Guidelines 87
- 5.12.3 Layout Guidelines 87
- 5.12.4 Application Notes 88
- 5.12.4.3 LPT/Floppy 89
- 5.12.4.4 EMI Considerations 89
- Parallel Port 90
- 6.2 Design Guidelines 95
- 8.1 Material of Heatsink 101
- 8.4 Grounding Issues 102
- 8.8.1 Vendor List 106
- 8.8.2 Heat-Spreader 106
- 8.8.3 Heat-Sink 107
- 8.8.4 Thermal Pad 108
- M2.5*6 5 109
- M2.5*16 5 109
- Quantity 109
- 8.8.6 Fan 110
Produits connexes et manuels pour PC/postes de travail Advantech MMP3-21
(30 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.100 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels