Advantech MIO-2260 Manuel d'utilisateur télécharger pdf (Page 20)

MIO-2260 User Manual 10

2.2.2.4 VGA/LVDS Interface Connections

The board's VGA interface can drive conventional CRT displays and is capable of

driving a wide range of flat panel displays, including passive LCD and active LCD dis-

plays. The board has connectors to support these displays: one for standard CRT

VGA monitors and one for flat panel displays

CRT display connector (CN17)

The CRT display connector is a rear I/O connector as coastline used for conventional

CRT displays. Resolution : up to 1400 x 1050 (SXGA)

LVDS LCD panel connector (CN3)

The board supports single channel 18-bit LVDS LCD panel displays via 14*1pin

wafer box. Resolution : up to 1366 x 768 (WXGA).

2.2.2.5 DDRIII SODIMM Socket (CN4)

One 204-pin/H9.2 mm DDRIII DIMM socket supports DDRIII 667 MHz up to 2 GB.

2.2.2.6 Audio Interface (CN5)

Audio Port Connectors

One 5 x 2 pin box header for Audio connector. These audio connectors are used for

audio devices.

2.2.2.7 Inverter Power/Internal SATA PowerConnector (CN6)

MIO-2260 can provide +5 V/+12 V/signal to LCD inverter board and 5V for 2.5" SATA

HDD via CN6.

SATA power's current is only sufficient for 2.5" HDD, and LVDS inverter's current is 5

V @ less than 1 A, 12 V @ 500 mA.

2.2.2.8 GPIO (General Purpose Input Output) (CN7)

The board supports 8-bit GPIO (5V tolerance) through GPIO connector. The 8 digital

in and out-puts can be programmed to read or control devices, with input or out- put

defined. The default setting is 4 bits input and 4 bits output.

2.2.2.9 Front Panel (CN8)

MIO-2260 integrates below functions as front panel 6pin connector :

Power button

MIO-2260 supports power on/off button in ATX mode.

Reset

If you install a reset switch, it should be an open single pole switch.

Momentarily pressing the switch will activate a reset.

Power LED

Power LED indicator would light when power is on.

HDD LED

HDD LED indicator for hard disk access is an active low signal

2.2.2.10 Mini PCIe Connector (CN9)

PCI Express Mini Card (also known as Mini PCI Express, Mini PCIe, and Mini PCI-E)

is a replacement for the Mini PCI form factor based on PCI Express. It is developed

by the PCI-SIG. The host device supports both PCI Express and USB 2.0 connectiv-

ity, and each card uses whichever the designer feels most appropriate to the task.

MIO-2260 support a Mini PCIe slot.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 85 86

Commentaires sur ces manuels

Pas de commentaire

Advantech MIO-2260 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères Advantech MIO-2260