Advantech AIMB-766 Manuel d'utilisateur télécharger pdf (Page 19)

11 ACP-1010 User Manual

Chapter 2 System Setup

2.5 Installing Disk Drives

ACP-1010 comes with two 3.5" disk drive bays for HDD and FDD. It also accepts one

slim type optical disk drive. To install any of these disk drives, please proceed as fol-

lows:

1. Open the front cover by pushing the latches.

2. Remove the four screws, which mount the slim-type optical disk drive and 3.5”

HDD brackets on the chassis.

3. Insert the hard drive disk into the proper location in the drive bay and fix it with 4

screws. It's also flexible to fix two 2.5" HDD instead of one 3.5" HDD. (see Fig-

ure 2.10)

4. Connect a suitable cable from the CPU card / motherboard to an IDE or a SATA

HDD.

5. Purchase a small PCB converter (see Figure 2.8) and connect it to the ATA

(IDE) slim-type ODD. Then fix it in place by tightening the two screws provided.

Or purchase a SATA power wire to connect it to the SATA slim-type ODD.

6. Insert slim-type optical disk drive into the proper location, and fix it with 4

screws.

7. Insert the proper power connector into each drive.

8. Return the HDD drive and slim-type optical disk drive with the bracket on the

chassis and fix it with four screws.

Figure 2.8 Small converter for ATA (IDE) slim-type ODD

Figure 2.9 Installing a slim ODD & HDD / FDD

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Pas de commentaire

Advantech AIMB-766 Manuel d'utilisateur Page 19