Advantech IPC-623 Series Manuel d'utilisateur télécharger pdf (Page 19)

13 Chapter 2

3. Select a vacant PICMG slot for the full-length CPU card or PCI/ISA

slot for other add-on cards and remove the corresponding I/O bracket

attached to the rear plate of the chassis.

4. Insert the CPU card or add-on card vertically into the proper slot (See

Figure 2.5 & Figure 2.6). For full-length cards, please make sure that

the card bracket has been inserted properly and the other edge of the

card has been inserted into the plastic guiding. Fasten the card by a

screw on top of the I/O bracket.

5. Repeat Step 3 and 4 if there is more than one add-on card.

6. There are two rows of notches on both sides of the hold-down clamp

for inserting the rubber cushions into. One side is for PCI cards, the

other side is for ISA cards. Depending on the card height, the cushions

can be inserted upward or downward. After the rubber cushions have

been inserted into the notches, they will stabilize the add-on cards to

protect them from shock and vibration. Use the shorter rubber cushions

to stabilize the full-length CPU cards.

7. Put back the hold-down clamp and screw it in place.

8. Replace the top rear chassis cover and fasten it.

Figure 2.4: Adjusting the location of thermal sensor

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Pas de commentaire

Advantech IPC-623 Series Manuel d'utilisateur Page 19