Advantech IPC-623 Series Manuel d'utilisateur télécharger pdf (Page 32)

IPC-623 User Manual 26

Figure 3.8: Replacing the single power supply

This extra drive bay in the front middle section can hold six 3.5" HDDs,

but we strongly suggest to install up to three HDDs so the system can

maintain good performance. To install the HDD into this drive bay,

please refer to Figure 3.9 and proceed as follows:

1. Loosen the four screws of the drive bay.

2. Adjust the HDD into position.

3. Fix the HDD to the disk drive bay by fastening the screws on both

sides of the drive bay.

4. Connect the disk drive power and signal cables.

5. Put back the middle disk drive bay to the chassis and fasten it.

6. Replace the top front cover and fasten it.

Figure 3.9: Installing 3.5” HDD to middle drive bay

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Pas de commentaire

Advantech IPC-623 Series Manuel d'utilisateur Page 32