Advantech IPC-623 Series Manuel d'utilisateur télécharger pdf (Page 21)

IPC-623 User's Manual

2.3 Chassis Front and Rear Sections

The IPC-623 comes in two sections: the front section and the rear section. Each of these sections has its

own top cover.

The front section includes:

1. Standard drive bay.

2. Three cooling fans.

3. Front chassis door.

4. Control panel.

5. Power supply (two power supply modules for the Power Redundant Supply Model; one power

supply module for the Single Power Supply Model).

6. Additional drive bay (for the Single Power Supply Model only).

The rear section includes:

1. Backplane.

2. Two temperature sensors.

3. Alarm board.

4. Hold-down clamp.

5. Power supply (for the ATX Motherboard System and the 14-slot System Model).

2.4 The Standard Drive Bay

The standard drive bay of the IPC-623 can hold up to three front accessible 5.25" drives, such as a

CD-ROM unit, a removable drive, a vertically mounted 3.5" floppy drive, or an internal 3.5" hard

drive.

Installing disk drives

1. Remove the top front cover.

2. Detach the four screws holding the standard drive bay.

3. Lift off the standard drive bay (please refer to figure 2-3).

4. Insert the drives into their proper locations in the drive bay and secure them with the screws provid-

ed.

5. Connect the disk drive power and signal cables.

6. Install the standard drive bay and secure the top front cover with the four screws.

Figure 2-2 Figure 2-3

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Pas de commentaire

Advantech IPC-623 Series Manuel d'utilisateur Page 21