Advantech SG-1103 Manuel d'utilisateur télécharger pdf (Page 44)

ROM-5420 User Manual 36

-v be more verbose for some error conditions

interface

The name of the interface. This is usually a driver name fol-

lowed by a unit number, for example eth0 for the first Ethernet

interface. If your kernel supports alias interfaces, you can

specify them with eth0:0 for the first alias of eth0. You can

use them to assign a second address. To delete an alias inter-

face use ifconfig eth0:0 down. Note: for every scope (i.e. same

net with address/netmask combination) all aliases are deleted,

if you delete the first (primary).

[aftype]

up This flag causes the interface to be activated. It is

implicitly specified if an address is assigned to the inter

face.

down This flag causes the driver for this interface to be shut down.

address The IP address to be assigned to this interface.

netmask [addr]

Set the IP network mask for this interface. This value defaults

to the usual class A, B or C network mask (as derived from the

interface IP address), but it can be set to any value.

broadcast [addr]

If the address argument is given, set the protocol broadcast

address for this interface. Otherwise, set (or clear)

the IFF_BROADCAST flag for the interface.

del addr/prefixlen

Remove an IPv6 address from an interface.

3.8.7 Storage (SATA /eMMC/SD Card)

The storages devices are named as follows:

Device Name

SATA /dev/sda

eMMC /dev/mmcblk0

SD card /dev/mmcblk1

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Pas de commentaire

Advantech SG-1103 Manuel d'utilisateur Page 44