Advantech PCI-1724U Manuel d'utilisateur télécharger pdf (Page 59)

51 Appendix D

3. Press [Default] button (IV). This action will load the factory default

value.

The value on the meter will change after you change the Adjust Value.

Please check the value on the meter is in the range again. If value fits the

condition, press the [Next] button to continue.

Figure D.10: The Adjustment Process of Offset Calibration

Step 6: After offset calibration, this step is to adjust Span. The Wizard

will output 20mA on the channel you selected. The steps of span calibra-

tion are quite similar to those of the offset calibration (Step 5). Follow the

instructions of the Calibration Wizard. If the value fits the condition,

press the [Next] button to continue.

1 2 ... 54 55 56 57 58 59 60 61 62

Pas de commentaire

Advantech PCI-1724U Manuel d'utilisateur Page 59