Advantech DLoG MTC 6 Series Manuel d'instructions télécharger pdf (Page 48)

WLAN

42 Manual V3.10 DLoG Config

Connect program

Start program on each

new connect or start

after ...

This setting is used to start any arbitrary software

program.

The program may optionally be started:

• after every entry into the WLAN area

• or periodically; if necessary, enter the time

interval.

If a WLAN connection exists, the program is

started at the specified intervals.

Note: the prerequisite is that there is a functioning

WLAN connection!

An application example: The DLoG Industrial PC on a

forklift has an online connection to the warehouse

management database. If the forklift leaves the WLAN

area, this online connection is interrupted. To receive

updated data immediately after entering the WLAN area

again, the Connect Program function is used to start a

database update automatically.

Program Enter the program to be started here.

Extended settings

Select WLAN card Detect the radio card automatically or select it from the

list (see also WLAN status window and radio cards next

page).

Finally, don't forget to Save!

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 67 68

Pas de commentaire

Advantech DLoG MTC 6 Series Manuel d'instructions Page 48