Advantech EKI-6311G Manuel d'utilisateur Page 1

1 EKI-6311G IEEE 802.11 b/g Wireless Access Point/Client Bridge User Manual

10 2.4 Basic Configuration 2.4.1 Basic Configuration Steps This section describes a two-step SYSTEM configuration procedure to se

11 Figure 2-5 Step3 : Enter “admin” in the Username and Password fields, and click LOGIN to enter the web configuration user inter

12 ● Log ● System Time ● Reboot ▽ NETWORK ● Network ● HotSpot ▽ WIRELESS ● Wi-fi 1 ● Wi-fi 2 ● Wi-fi 3 ● Wi-fi 4 ▽ AC

13 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G ► LAN Settings These are the s

14 The IP address of the AP on the local area network. Assign any unused IP address in the range of IP addresses available for the L

15 2.4.4 Set Wireless SSID for Wireless Interface ► Wireless Network Name （Also called the SSID） When you are browsing for availab

16 2.4.5 Set Wireless Encryption for Wireless Interface The EKI-6311G supports 64-bit and 128-bit WEP encryption. For 64-bit WEP

17 2.4.6 Change Supervisor Account & Password Enter the SYSTEM > Administrator page. Figure 2-10 below shows the SYSTEM / A

18 2.4.7 Upgrade the Firmware ► Update the Firmware Enter the SYSTEM > FIRMWARE page as shown in Figure 2-11 to upgrade EKI-63

19 2.4.8 DHCP server ► DHCP server Enter the Network > Network page as shown in Figure 2-12 to Enable the DHCP server. Here, u

2 Contents Chapter 1. Introduction... 4 1.1 Introducing

20 Chapter 3. Network Topologies This chapter describes several common types of installations implemented by using the EKI-6311G’s

21 3.1 Wireless Client Bridge-to-Central Wireless Bridge Figure 3-2 Refer to Figure 3-2 for the following setup. Note: The EKI-63

22 Chapter 4. All function on Device 4.1 SYSTEM 4.1.1 Administrator Administrator Settings Use this menu to restrict management a

23 4.1.2 Firmware Figure 4-2 Firmware Update – WEB You can use WEB to upgrade the firmware. The "firmware information" d

24 respond to commands for as long as ten minute. This is normal behavior and do not turn off the Wireless device during the time. F

25 4.1.3 Configuration Tools Figure 4-3 Restore Factory Defaults - Reset the device's configuration settings to the factory

26 4.1.4 Status Figure 4-4 You can use the Status screen to see the connection status for the LAN and Wireless LAN interfaces. It

27 4.1.5 Log Figure 4-5 The Access Point automatically logs (records) events of possible interest in its internal memory. If ther

28 4.1.6 System Time Figure 4-6 The Time Configuration option allows you to configure, update, and maintain the correct time on d

29 4.1.7 Reboot Figure 4-7 Reset Wireless device. In the event that the Wireless device stops responding correctly or in some way

3 4.4.4 ACL for Wi-Fi 4 ... 36 4.5 SNMP ...

30 4.2 NETWORK 4.2.1 Network 4.2.1.1 Operating Mode-Access Point IP Assignment DHCP Choose "DHCP (Dynamic)" if your r

31 Subnet Mask The subnet mask of the local area network. Gateway The IP address of the router on the local area network. DNS S

32 PPPoE Choose "PPPoE" if your Internet support PPPoE Server .You need keyin Username and Password to login PPPoE Server.

33 4.2.2 HotSpot（Captive Portal） HotSpot: Enable/Disable captive portal function. Note, the device will become router mode and ALL

34 4.3 WIRELESS You can set the wireless releated setting here Figure 4-12

35 4.3.1 Wi-Fi 1 Wireless Settings Radio Status: Enable/Disable SSID. Wireless Role: This SSID will act as Station or Access Point.

36 4.4 ACL You can set the access control releated setting here Figure 4-13 4.4.1 ACL for Wi-Fi 1 Wireless MAC ACL Wireless MAC

37 4.5 SNMP You can set the SNMP Community and SNMP Trap setting here 4.5.1 Agent Settings SNMP Agent provides a simple protection

38 Chapter 5. Specifications The EKI-6311G Outdoor Wireless Access Point/Multi-Client Bridge/ WDS (wireless distribution system) o

39Features z High Speed Data Rate Up to 54Mbps z Power-over-Ethernet (IEEE802.3af Compliant) z Output Power up to 19dBm z I

4 Chapter 1. Introduction 1.1 Introducing the EKI-6311G The EKI-6311G is fully interoperable with IEEE 802.11b/g compliant Wireles

40Networking Topology Ad-Hoc, Infrastructure Operation Mode Access Point / CB+AP / AP Router / CB+AP Router / HotSpot AP / VLAN AP

41Chapter 6. Default Settings 6.1 SYSTEM 6.1.1 Administrator Parameter Description Default Value Hostname Advantech.lan Cu

426.1.5 Log 6.1.6 System Time Parameter Description Default Value Setting by Synchronize with an Internet Time Server Year /

436.2 NETWORK 6.2.1 Network Parameter Description Default Value Operating Access Point IP Assignment Manual IP Address 19

446.3 WIRELESS 6.3.1 Wi-Fi 1 Parameter Description Default Value Country TAIWAN Radio Status Enable Wireless Role Access P

456.3.2 Wi-Fi 2 Parameter Description Default Value Country TAIWAN Radio Status Disable Wireless Role Access Point Radio Mo

466.3.3 Wi-Fi 3 Parameter Description Default Value Country TAIWAN Radio Status Disable Wireless Role Access Point Radio Mo

476.3.4 Wi-Fi 4 Parameter Description Default Value Country TAIWAN Radio Status Disable Wireless Role Access Point Radio Mo

486.4 ACL 6.4.1 ACL for Wi-Fi Parameter Description Default Value Wireless MAC ACL Status Disable Add New MAC Address 00:0

496.4.3 ACL for Wi-Fi 3 Parameter Description Default Value Wireless MAC ACL Status Disable Add New MAC Address 00:00:00:00:

5 1.4 System Requirements Installation of the EKI-6311G Outdoor Wireless Access Point/Client Bridge requires the following: 1. A

506.5 SNMP Parameter Description Default Value Agent Status Enable System Location System Contact System Name Advantech

51Chapter 7. Regulatory Compliance Information Federal Communication Commission Interference Statement This equipment has been

52 Antenna type Antenna GainOmni 5dBi

6 Chapter 2. Installation and Basic Configuration This chapter describes the procedures of installing the EKI-6311G. 2.1 Before

7 2.2 Locate the EKI-6311G and Inline Power Injector Ports ► Interface on the EKI-6311G Unit ¾ Ethernet Port 1 : for connectin

8 ► Mount EKI-6311G on A Wall/Mast The EKI-6311G can be mounted on the wall, you can use the Wall Mount kit to mount the EKI-6311G a

9 2.3 Preparing Installation Before installing EKI-6311G for outdoor application or hard-to-reach location, we recommend configuri