Advantech UniGateway EH-2101W Manuel d'utilisateur télécharger pdf (Page 10)

Introduction

10/100BaseT

LAN connections

Use standard LAN cables (RJ45 connectors) to connect your PCs to

these ports.

The "Uplink" port can be used to connect to a standard port on

another Hub, using a standard LAN cable.

Use EITHER "Port 1" OR the "Uplink" port.

You can NOT use both.

Printer Port

Standard parallel printer port. If you wish to share a printer, connect

it here.

DIP Switches

DIP Switch Set-

ting

Description

1=off

2=off

Normal Operation.

1=off

2=on

DHCP Server function disabled.

1=on

2=off

Used to restore Default IP Address

and clear Password (See below).

1=on

2=on

Normal Operation.

Restore Default IP Address and Clear Password

If the UniGateway EH-2101W's IP Address or password is lost, the following procedure can

be used to recover from this situation.

1. Turn the power to the UniGateway EH-2101W OFF.

2. Set DIP switch 1 ON.

3. Turn the power to the UniGateway EH-2101W ON.

4. Operate DIP switch 1 in the following sequence (you have 15 seconds to complete the

sequence):

• OFF

• ON

• OFF

5. The UniGateway EH-2101W will now reset, and the Red Status LED flash. The following

changes will have been made. (Other configuration data is unchanged.)

• IP Address set to its default value of 192.168.0.1

• Network Mask set to 255.255.255.0

• DHCP Server is enabled, and will allocate IP Addresses in the range 192.168.0.2 to

192.168.0.51.

• The password cleared (no password).

6. You can now connect to the UniGateway EH-2101W and make any configuration changes

required

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Advantech UniGateway EH-2101W Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Advantech UniGateway EH-2101W